Plumbing Takeoff Services
Plumbing takeoff counts fixtures, pipe footage, and equipment checked against IPC/UPC code, built for plumbing contractors and estimators preparing a bid. Most takeoffs are delivered in 24-48 hours, with pricing typically $300-$2,000 depending on fixture count and system scope. Estimates are billed at $30-$45 per hour.
Fixture counts, pipe footage, fittings, and equipment, taken off system by system and checked against code.
A plumbing takeoff has to separate systems that often share the same riser shaft but behave very differently when it comes to material, sizing, and code compliance. We take off domestic water, sanitary drainage, storm drainage, and gas piping as four distinct systems, each by pipe size, material (copper, PVC, CPVC, cast iron, or PEX depending on application), and footage, rather than lumping them into a single blended linear-foot number. Fixture counts are taken directly from the fixture schedule and plan, broken out by type, water closets, lavatories, sinks, floor drains, and connection size, since fixture unit loads drive both sanitary pipe sizing and domestic water demand calculations under IPC or UPC, whichever code the jurisdiction has adopted.
Fittings and valves are counted by type and size rather than estimated as a percentage add-on to pipe footage. Shutoff valves, check valves, backflow preventers, and cleanouts each carry distinct material and labor costs, and a project with frequent direction changes or extensive valving, a hospital or lab building, for example, will carry meaningfully more fitting cost per linear foot of pipe than a simple tenant improvement. Equipment, water heaters, booster pumps, sump and sewage ejector pumps, and grease interceptors, is scheduled separately with capacity and connection requirements noted, since equipment lead times and specification compliance often drive the procurement schedule independent of the pipe and fixture package.
Where a project includes specialty piping, medical gas, laboratory waste and vent, or compressed air, we take that scope off separately from standard plumbing systems, since these carry their own code requirements (NFPA 99 for medical gas in healthcare facilities, for example) and require specialized valve, alarm panel, and material certifications that a generic plumbing estimate would miss. Every system is checked for code compliance as part of the takeoff, confirming venting, trap sizing, and fixture unit calculations against IPC or UPC requirements, so the final estimate reflects a design that will actually pass plan review, not just a drawing that was measured without a compliance check.
Every Deliverable, Itemized
- Fixture counts by type and connection size from the fixture schedule
- Pipe footage by system (domestic water, sanitary, storm, gas) and material
- Fittings and valves counted by type and size, not estimated as a percentage
- Equipment scheduling: water heaters, pumps, backflow preventers, interceptors
- Specialty system takeoff: medical gas, lab waste/vent, compressed air
- IPC/UPC code compliance review for venting, trap sizing, and fixture units
Most Standard Estimates in 24-48 Hours: exact timeline confirmed with your quote.
Common Questions
What's included in a plumbing takeoff?
Our plumbing takeoff includes fixture counts by type and connection size, pipe footage by system (domestic water, sanitary, storm, gas) and material, fittings and valves, and equipment such as water heaters, pumps, and backflow preventers, checked against IPC or UPC code requirements.
Do you separate domestic water from sanitary and storm piping?
Yes. Domestic water, sanitary drainage, storm drainage, and gas piping are each taken off and priced as separate systems, since pipe material, sizing method, and code requirements differ between systems even within the same building.
Can you estimate medical gas or specialty piping systems?
Yes. Medical gas, lab waste and vent, and other specialty piping systems are taken off separately from standard plumbing scope, with material, valve, and alarm panel requirements priced to the applicable code, typically NFPA 99 for medical gas in healthcare facilities.
Ready to Get Started?
Submit your plumbing drawings and fixture schedule for a detailed, code-checked takeoff.